How to remove an embroidered logo

REMOVE is the verdict for this kind of logo

An embroidered logo comes out with a seam ripper and tweezers, one stitch at a time. Plan on 30 minutes for a small chest logo and a few hours for a big back piece.

Steps

  1. 1Grab a seam ripper, tweezers, and a podcast.

    A lint roller helps too. Go slowly. Every fabric is a little different, and the point of the ripper can catch the fabric if you rush.

  2. inside out

    2Turn it inside out and find the stitches.

    You’ll see the back of the embroidery, sometimes with a stiff backing sheet. Look for the bobbin thread: a slightly different white running down the middle of each letter.

  3. 3Cut the bobbin thread in small sections with the seam ripper.

    It’s about a third of the stitches, and cutting it loosens the rest. On a stiff backing, a cheap disposable razor drawn lightly across the back works too.

  4. 4Turn it right side out and pull the loose threads off the front.

    The top threads come away easily now. A lint roller lifts most of them, and tweezers get the stragglers. Peel away any backing from the inside.

  5. 5Brush it, steam it, and wash it.

    Go over the area with a lint shaver or a soft brush, then steam it or iron it on low through a damp cloth. Small needle holes usually close up after a wash or two.

LOGOLOGOREDACTED

Tips

  • Not half done at 45 minutes? That’s a good place to stop and cover what’s left with a patch.
  • Down jacket or puffer? Only cut stitches on the outer layer. A logo sewn through to the lining can let the down out.

Didn’t come off?

  • Holes still showing? Dense blocks of stitching leave so many needle holes that the fabric looks like a screen. On fleece and knits they close. On woven fabric, like a dress shirt, they stay.
  • Fabric starting to tear? Thin fabric, like a performance polo, can tear as stitches pop. Work from the back and keep the ripper’s ball end against the fabric.
  • Is it a cap? Caps have a stiff backing glued to the front panel, and taking the logo out usually leaves the panel cut and dented. A patch is the better fix.
  • Paid a lot for it? A tailor can take the logo out for you.

Get the tools

The unswag kit has its own seam ripper, so kit owners can skip buying it. $30. Ships free.

As an Amazon Associate I earn from qualifying purchases.

Stuck, or done?

Logo won’t budge, or not sure what kind it is? Send a photo to [email protected] and I’ll tell you what I’d try next. A real person reads every one.

If it worked, send the before and after too. We’ll ask before anything goes up on the Before and after wall.

Quinn

More guides