How to remove a vinyl logo from a shirt or hoodie

REMOVE is the verdict for this kind of logo

Heat-transfer vinyl peels off in 10 to 15 minutes with an iron or hair dryer and a plastic scraper. It works on cotton and cotton blends, and adhesive remover takes care of the glue left behind.

Steps

  1. GLUE OFF

    1Grab an iron and a thin cloth, or a hair dryer, plus a plastic scraper and adhesive remover.

    On polyester or anything stretchy, use the hair dryer. An iron can melt synthetics. Test the adhesive remover inside a seam before you start, since every fabric and dye is a little different.

  2. 2Turn it inside out and heat the back of the logo for 20 to 30 seconds.

    Heat from the back softens the glue. With an iron, keep the thin cloth between the iron and the fabric.

  3. LOGO

    3Turn it right side out, lift a corner with the scraper, and peel while it’s warm.

    Peel slowly, keeping the vinyl low and close to the fabric. Warm vinyl comes away in a sheet.

  4. LOGO

    4When it starts to resist, heat it again.

    Short rounds of heat work better than one long blast. Old vinyl may come off in flakes instead of one sheet, so give it extra time.

  5. GLUE OFF

    5Clean up the leftover glue, then wash it.

    Lay a scrap of cotton over the glue, press with the warm iron for a few seconds, and peel the scrap off while it’s still warm. The glue comes away with it. Let the fabric cool, wipe off what’s left with adhesive remover, and wash the item.

ACETONE

Tips

  • Never heat a solvent. Adhesive remover and acetone go on cool fabric only, after the iron or hair dryer is put away. Many are flammable.
  • Acetone is a last resort. It took an old print off our nylon and polyester backpack, after a test spot. It can also strip dye, and it dissolves acetate and a few other synthetics. Test inside a seam, open a window, and keep it away from flames.

Didn’t come off?

  • Coming off in flakes? The vinyl is old and cracked. Each piece needs its own heat and lift. Give it an hour, or cover it.
  • Glue won’t let go of polyester? Synthetics hold glue harder than cotton. Stick with the hair dryer, and expect some residue to stay.
  • Darker patch where the logo was? The vinyl kept that spot from fading in the wash. The shadow fades over several washes, and it may never match.
  • Nothing to peel? It’s probably screen print, which is ink in the fabric, not a film on top. A patch covers it.

Get the tools

The unswag kit has its own scraper, so kit owners can skip buying it. $30. Ships free.

As an Amazon Associate I earn from qualifying purchases.

Stuck, or done?

Logo won’t budge, or not sure what kind it is? Send a photo to [email protected] and I’ll tell you what I’d try next. A real person reads every one.

If it worked, send the before and after too. We’ll ask before anything goes up on the Before and after wall.

Quinn

More guides