How to cover a logo on a bottle, mug, or laptop

COVER is the verdict for this kind of logo

A sticker covers a logo that won’t come off in about five minutes. It holds best on a flat, clean surface, so clean the spot with alcohol first.

Steps

  1. UNSWAGALCOHOL

    1Grab a cover sticker, rubbing alcohol, a soft cloth, and a plastic scraper.

    Pick a sticker a little bigger than the logo. On a curved bottle or mug, a small round one holds best.

  2. ALCOHOL

    2Clean the spot with a little alcohol.

    Oils and dust are what make stickers peel. Wipe the logo and a little around it.

  3. 1 min

    3Let it dry completely.

    Any alcohol left on the surface keeps the sticker from gripping.

  4. UNSWAG

    4Line it up before it touches, then press from the middle out.

    A sticker gets less sticky every time you lift it, so hold it just above the logo until it’s where you want it.

  5. UNSWAG

    5Smooth out bubbles with the scraper.

    Run the edge across the sticker from the middle toward the sides, then press the edges down with a finger.

UNSWAGyeswrinkles

Tips

  • Hand wash it. Dishwashers peel stickers within a few cycles.

We tried it

On October 8 a power bank’s print wouldn’t come off, even with acetone, so we covered it with a sticker.

Power bank, before
Before
Power bank, after
After

If it doesn’t hold

  • Lifting at the corners? Tight curves, like a bottle’s shoulder, fight a flat sticker. Use a small round one, or move to a flatter spot.
  • Peeling on textured plastic? Soft-touch and textured finishes give glue less to grip. Clean with alcohol and press hard. Even then, expect it to lift sooner.
  • Logo showing through? Raised or engraved logos show as a bump. A thicker vinyl sticker hides them better than a thin one.

Get the tools

Sticker sheet, eight designs

Sticker sheet

Sheet: 5.8 × 8.3 in, eight designs.

The unswag kit has its own scraper and alcohol prep pads, so kit owners can skip buying them. $30. Ships free.

As an Amazon Associate I earn from qualifying purchases.

Stuck, or done?

Logo won’t budge, or not sure what kind it is? Send a photo to [email protected] and I’ll tell you what I’d try next. A real person reads every one.

If it worked, send the before and after too. We’ll ask before anything goes up on the Before and after wall.

Quinn

More guides