How to get a logo off a water bottle, laptop, or gadget

Most logos on bottles, laptops, and gadgets are stickers, printed ink, or engraved. Stickers peel with a little heat, some prints wipe off with rubbing alcohol, and engraved logos stay put, so cover those.

Steps

  1. ALCOHOL

    1Grab rubbing alcohol, cotton pads, a hair dryer, and a plastic scraper.

    Use 70% alcohol or higher. A microfiber cloth works in place of the pads.

  2. stickerprintedengraved

    2Figure out what kind of logo you’ve got.

    A sticker or decal has an edge you can catch with a fingernail. A printed logo is flat ink with no edge. An engraved logo is cut into the surface and usually looks frosted or darker than the material around it. Engraved logos don’t come off at home, so skip to covering it.

  3. LOGO

    3Sticker or decal? Warm it, lift an edge, and peel slowly.

    Hair dryer on medium for 20 to 30 seconds, then the plastic scraper under one corner. Clean the leftover glue with a little alcohol on a pad.

    On a laptop, speaker, or anything with a battery, use low heat and short bursts. Screens and batteries don’t like heat, so keep the dryer on the sticker and off everything else.

  4. LOGOALCOHOL

    4Printed on plastic? Test alcohol on a hidden spot, then rub gently.

    If the surface looks fine after a minute, rub the logo in small circles with a damp pad. Some inks come right off, and some won’t move. If nothing changes after a few minutes, stop. On clear acrylic, skip the alcohol: it can leave a haze or fine cracks.

  5. LOGO

    5Electronics? Power off, and dampen the cloth, never the device.

    Unplug it and keep liquid away from ports, buttons, and speaker grilles. On a power bank, or anything with an open seam, skip the alcohol and cover the logo with a sticker.

UNSWAG

Tips

  • Skip acetone on anything plastic or coated. It softens plastic and strips finishes. Rubbing alcohol is as strong as we’d go.

We tried it

In October we tried this on a hard cooler, a clear keychain, and a power bank. The cooler’s decal peeled off clean. Acetone took most of the print off the keychain and left it cloudy. The power bank’s print went gummy and stayed, so it got a sticker.

Didn’t come off?

  • Engraved steel? Most insulated bottles have the logo cut into the metal. Nothing at home removes it, and grinding leaves a worse mark. Cover it.
  • A ceramic mug? The logo is fired into the glaze, so it’s permanent. Cover it, and hand wash so the sticker lasts.
  • Finish clouding or going sticky? Stop. Coated and clear plastic lose their finish before the logo does. Cover what’s left.

Get the tools

The unswag kit has its own scraper and alcohol prep pads, so kit owners can skip buying them. $30. Ships free.

As an Amazon Associate I earn from qualifying purchases.

Stuck, or done?

Logo won’t budge, or not sure what kind it is? Send a photo to [email protected] and I’ll tell you what I’d try next. A real person reads every one.

If it worked, send the before and after too. We’ll ask before anything goes up on the Before and after wall.

Quinn

More guides