How to peel a sticker or decal off a water bottle
REMOVE is the verdict for this kind of logo
Most stickers and decals come off a water bottle in about five minutes with a hair dryer and a plastic scraper, and the glue they leave behind wipes off with rubbing alcohol. The same steps work on coolers, tumblers, and other metal, hard plastic, or coated surfaces.
Steps
-
1Grab a hair dryer, a plastic scraper, rubbing alcohol, and a soft cloth.
If the item is new, look for a clear protective film over the logo before you start. Sometimes the sticker sits on the film, and the whole thing peels off in one go.
Test the alcohol on a hidden spot first, like the underside or the back. Every surface is a little different.
-
2Warm the sticker for 20 to 30 seconds.
Hair dryer on medium, a few inches away, and keep it moving so you don’t cook one spot. Warm glue lets go. Cold glue holds on, and the sticker tears instead.
-
3Lift a corner with the plastic scraper.
Slide the edge under the sticker until there’s enough to pinch. Leave the knife or the razor blade in the drawer. They can scratch most surfaces.
-
4Peel it slowly, keeping it low and folded back on itself.
Pull along the surface, not straight up. Going low puts the force on the glue instead of the sticker. If it starts to tear, stop, warm it again, and pick up where you left off.
-
5Clean up the leftover glue.
Press the sticky side of the peeled sticker onto the residue and lift. Wipe the rest with a little alcohol on the cloth, then dry it off. On clear acrylic, skip the alcohol: it can leave a haze or fine cracks.
Tips
- Don’t wait on it. Sun fades everything around a sticker, so the longer it stays on, the sharper the outline it leaves behind.
- Old or sun-baked decal? It’ll probably come off in chips. Warm a small section, peel what lifts, and repeat. It’s slow, but it gets there.
We tried it
On October 9 we took a vinyl decal off a hard cooler. The kit’s plastic scraper got under the edge, the decal peeled off, and rubbing alcohol cleaned up the glue. Here’s the before and after, and the whole thing on video.
Didn’t come off?
- No edge, even after heating? The decal is probably sealed under a clear coat, which makes it part of the finish. There’s nothing to peel, so cover it.
- Still tacky? Soft and rubbery plastics, like silicone sleeves and grips, soak up glue. Alcohol gets most of it, and a little stickiness may stay.
- Paint coming up with it? Stop there. Weak paint will keep lifting, and covering the logo is the better fix.
Get the tools
The unswag kit has its own scraper and alcohol prep pads, so kit owners can skip buying them. $30. Ships free.
As an Amazon Associate I earn from qualifying purchases.
Stuck, or done?
Logo won’t budge, or not sure what kind it is? Send a photo to [email protected] and I’ll tell you what I’d try next. A real person reads every one.
If it worked, send the before and after too. We’ll ask before anything goes up on the Before and after wall.
Quinn


